Alternator: Service and Repair

GENERATOR REPLACEMENT

REMOVAL PROCEDURE
1. Disconnect negative battery cable.
2. Remove the drive belt.
3. Disconnect the electrical connectors from the generator.




4. Remove the generator bolts.
5. Remove the generator.

INSTALLATION PROCEDURE




1. Install the generator.
2. Install the generator bolts.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the generator bolts to 20 N.m (15 lb ft).

3. Connect the generator electrical connectors.

Tighten the generator electrical connector to 17 N.m (13 lb ft)

4. Install the drive belt.
5. Lower the vehicle.
6. Connect the battery negative cable.