Crankshaft Position Sensor: Service and Repair

CRANKSHAFT POSITION (CKP) SENSOR REPLACEMENT

REMOVAL PROCEDURE
1. Remove the starter.




2. Disconnect the crankshaft position (CKP) sensor harness connector.
3. Remove the CKP sensor bolt.
4. Remove the CKP sensor.

INSTALLATION PROCEDURE
1. Inspect the CKP sensor O-ring and lubricate with a mineral based grease.




2. Insert the CKP sensor into the block.
3. Install the CKP sensor bolt.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the bolt to 8 N.m (71 lb in).