LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2005 >> Classic >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Lighting Systems) >> Repair Instructions >> High Mounted Stop Lamp Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Am and 2004 Oldsmobile Alero. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Bulb & Socket
    GM737333Courtesy of GENERAL MOTORS CORP.
  1. Install the bulb(s) to the socket(s), if required.
    2. Fig 2: Installing The Lens To The High Mounted Stop Lamp Housing
    GM737328Courtesy of GENERAL MOTORS CORP.
  2. Install the lens to the high mounted stop lamp housing by aligning the tabs on the lens to the housing and press into place until fully seated, if required.
    3. Fig 3: View Of High Mounted Stop Lamp Housing & Electrical Connector
    GM329503Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector to the high mounted stop lamp.
  4. Install the high mounted stop lamp to the rear compartment lid, pressing into place until the retainers hold the housing.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: Inspect the gasket to the lens for proper fit while tightening the nuts.
  5. Install the nuts to the high mounted stop lamp.

    Tighten:  Tighten the high mounted stop lamp nuts to 2 N.m (18 lb in).

  6. Close the rear compartment.
scientia non olet · About LEMON Manuals