LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2005 >> Classic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - Introduction & Repair Instructions >> Repair Instructions >> Low/Reverse Servo Assembly Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Assemble the low/reverse servo. Refer to Low and Reverse Servo Assemble and Installation in Automatic Transmission Transaxle Unit Repair Manual.
    2. Fig 1: View Of Low/Reverse Servo Assembly
    GM588858Courtesy of GENERAL MOTORS CORP.
  2. Install the low/reverse band servo cover bolts.

    Tighten:  Tighten the bolts to 12 N.m (106 lb in).

  3. Install the oil feed pipe. Refer to Oil Feed Pipes Replacement .
  4. Install the oil filter and pan. Refer to Oil Filter and Seal Replacement .
  5. Lower the vehicle.
  6. Connect the negative battery cable.
  7. Fill the transmission. Refer to Fluid Capacity Specifications .
  8. Inspect the transmission fluid level. Refer to Transmission Fluid Checking Procedure .
scientia non olet · About LEMON Manuals