Body Control Module (BCM) - Programming & Setup

Body Control Module Programming and Setup

Each of the following courses of action requires a setup or programming procedure before the body control module (BCM) can be put into normal service.

Body Control Module (BCM) Replacement

If the BCM is replaced, the following procedures must be performed in the subsequent order:

- BCM Reprogramming--Refer to Body Control Module (BCM) Programming/RPO Configuration.
- Brake Pedal Position Sensor Calibration--Refer to Brake Pedal Position Sensor Calibration.

Sensing and Diagnostic Module (SDM) Replacement

If the sensing and diagnostic module (SDM) is replaced, the following procedure must be performed:

Setup SDM Part Number in BCM. Refer to Body Control Module (BCM) Programming/RPO Configuration.

Brake Apply Sensor (BAS) Replacement

If the brake apply sensor (BAS) is replaced, the following procedures must be performed:

- BCM Reprogramming--Refer to Body Control Module (BCM) Programming/RPO Configuration.
- Brake Pedal Position Sensor Calibration--Refer to Brake Pedal Position Sensor Calibration.

Body Control Module (BCM) Reprogramming

If the BCM is reprogrammed, the following procedures must be performed:

- BCM Reprogramming--Refer to Body Control Module (BCM) Programming/RPO Configuration.
- Brake Pedal Position Sensor Calibration--Refer to Brake Pedal Position Sensor Calibration.