Wiring Systems - Introduction And Repairs
- Diagnostic Information and Procedures
- Electrical Symbols
- General Electrical Diagnosis Procedures
- Checking Aftermarket Accessories
- Circuit Testing
- Using Connector Test Adapters
- Probing Electrical Connectors
- Troubleshooting with a Digital Multimeter
- Troubleshooting with a Test Lamp
- Using Fused Jumper Wires
- Measuring Voltage
- Measuring Voltage Drop
- Measuring Frequency
- Testing for Continuity
- Testing for Short to Ground
- Testing for a Short to Voltage
- Testing for Intermittent Conditions and Poor Connections
- Inducing Intermittent Fault Conditions
- Testing for Electrical Intermittents
- Scan Tool Snapshot Procedure
- Circuit Protection - Fuses
- Circuit Protection - Circuit Breakers
- Circuit Protection - Fusible Links
- Wiring Repairs
- Repairing Damaged Wire Insulation
- Flat Wire Repairs
- Heated Oxygen Sensor (HO2S) Wiring Repairs
- Splicing Copper Wire Using Splice Clips
- Splicing Copper Wire Using Splice Sleeves
- Splicing Twisted or Shielded Cable
- Splicing Inline Harness Diodes
- SIR/SRS Wiring Repairs
- Connector Repairs
- Connector Position Assurance Locks
- Terminal Position Assurance Locks
- Push to Seat Connectors
- Pull to Seat Connectors
- Weather Pack Connectors
- Micro-Pack 100W Connectors
- Micro .64 Connectors
- Repairing Connector Terminals
- Schematic and Routing Diagrams
- Repair Instructions
- Special Tools and Equipment