LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2005 >> Venture LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 432 (Electronic Suspension System - Automatic Level Control) >> Repair Instructions >> Automatic Level Control Sensor Link Ball Stud Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the ELC/TRAILER fuse.
  2. Raise and support the vehicle. Refer to LIFTING & JACKING VEHICLE .

    Important  : When removing the link, do NOT bend or break the sensor arm.

    3. Fig 1: Automatic Level Control Sensor Link Ball Stud
    G01828552Courtesy of GENERAL MOTORS CORP.
  3. Remove the automatic level control sensor link from the tie rod ball stud.
  4. Remove the ball stud from the rear axle tie rod.
scientia non olet · About LEMON Manuals