LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2006 >> Corvette Base, 2D Convertible, Standard >> Repair and Diagnosis >> Engine Mechanical >> Engine Exhaust System >> Diagnostic Information and Procedures >> DTC P166A >> Circuit/System Testing
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Circuit/System Testing

  1. Ignition OFF, disconnect the exhaust flow control valve solenoid connector.
  2. Ignition ON, measure for 0 volts between the exhaust valve solenoid supply voltage circuit and ground.
    • If over 0 volts, test for short to voltage in exhaust valve solenoid supply voltage circuit.
  3. Ignition ON, use scan tool to command exhaust flow control relay ON, measure for 10 volts or above between the exhaust valve solenoid supply voltage circuit and ground.
    • If under 10 volts, test for short to ground in exhaust valve solenoid supply voltage circuit.
  4. If all circuits test normal replace the Exhaust Flow Control Module.
scientia non olet · About LEMON Manuals