LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2006 >> HHR LS, Standard >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Battery Positive Cable Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Positive Battery Cable Terminal From Junction Block Stud
    GM1631516Courtesy of GENERAL MOTORS CORP.
  1. Install the positive battery cable to the inside the vehicle.
  2. From inside the vehicle, route the engine compartment portion of the positive battery cable through the front of dash.
  3. Install the positive battery cable to the body harness clip (4).
  4. Install the positive battery cable clips (2) to the ECM/TCM bracket.
  5. Install the positive battery cable terminal (1) to the junction block stud.
    6. Fig 2: Positive/Negative Battery Cable Terminal
    GM1631518Courtesy of GENERAL MOTORS CORP.
  6. Install the positive/negative battery cable terminal (2) to the stud.
    7. NOTE: Refer to Fastener Notice in Cautions and Notices.
  7. Install the junction block terminal nut (1).

    Tighten:  Tighten the nut to 15 N.m (11 lb ft).

  8. Close the junction block terminal cover.
    9. Fig 3: Rubber Grommet
    GM1631511Courtesy of GENERAL MOTORS CORP.
  9. Install the rubber grommet (2) to the front of dash.
  10. Install the positive battery cable (3) to the clips (1) on the body harness.
    11. Fig 4: Positive Battery Cable
    GM1631513Courtesy of GENERAL MOTORS CORP.
  11. Install the positive battery cable clips (1) to the floor panel studs.
  12. Install the positive battery cable (2) to the clips (3) on the body harness.
    13. Fig 5: Positive Battery Cable Clips
    GM1631514Courtesy of GENERAL MOTORS CORP.
  13. Install the positive battery cable clips (1, 2) to the rear compartment panel studs.
    14. Fig 6: Body Harness Electrical Connector
    GM1631519Courtesy of GENERAL MOTORS CORP.
  14. Connect the body harness electrical connector (2) to the positive battery cable connector.
    15. Fig 7: Positive Battery Cable Clips
    GM1631515Courtesy of GENERAL MOTORS CORP.
  15. Install the positive battery cable clips (3, 4) to the studs.
  16. Install the positive battery cable from the battery.
  17. Tighten the positive battery cable nut (1).

    Tighten:  Tighten the nut to 15 N.m (11 lb ft).

  18. Close the positive battery cable cover (2).
  19. Install the carpet. Refer to Carpet Replacement .
  20. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .
scientia non olet · About LEMON Manuals