Installation Procedure
WARNING: This page is about a different car, the 2007 Chevrolet HHR. However, it is still accessible from the selected car via links, so may be relevant.
- Install the switch retainer to the pedal bracket with the retainer indexing arrow facing down, if previously removed.
- Connect the cruise control release switch electrical connector.
- Pull back lightly on the brake pedal to ensure the system is fully released.
- While lightly holding the pedal, install and adjust the cruise release switch:
- Insert the cruise release switch into the retainer.
- Ensure the switch plunger is fully depressed against the switch contact rubber bumper without deflecting the bracket or the switch contact arm on the pedal.
- Rotate the switch clockwise to secure the switch in the retainer.
- Release the brake pedal and inspect the switch barrel to switch contact rubber bumper clearance (1).
Specification: Clearance should not exceed 1.2 mm (0.047 in).
- Ensure the following contacts open at 25.4 mm (1 in) or less of pedal travel:
- The cruise release switch.
- The stop lamp and torque converter clutch (TCC) switch.
- Ensure the switches open simultaneously or before the onset of braking.
- The brake pedal may travel up to 25.4 mm (1 in) before the cruise control system disengages.
- Install the I/P sound insulator. Refer to Instrument Panel Insulator Replacement .