Conditions for Running the DTC

DTCs P0053, P0054, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0131, P0132, P0134, P0135, P0137, P0138, P0140, P0141, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0220, P0442, P0443, P0446, P0449, P0455, P0496, P1258, P1516, P2101, P2108, P2135, P2176 are not set.
DTC P0053 and P0054 have run and passed since the last code cleared.
The ECT Sensor parameter is more than 60°C (140°F).
The EVAP Purge Solenoid Command parameter is more than 1 percent.
The MAF Sensor parameter is between 18-55 g/s.
The Engine Speed parameter is between 1,000-3,000 RPM.
The TP Indicated Angle parameter is 5 percent more than the value observed at idle.
The Loop Status parameter is closed.
The Ignition 1 Signal parameter is between 10-18 volts.
The Fuel Tank Level Remaining parameter is more than 10 percent.
The Engine Run Time parameter is more than 160 seconds.
The above conditions are met for one second.
This diagnostic runs one time per drive cycle when the above conditions are met.