Removal Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Turn the ignition switch to the OFF position.
Remove the IP accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement .
Remove the HVAC Control Module. Refer to HVAC Control Module Replacement .

Fig 1: View Of Yaw Rate Sensor & Nuts

Courtesy of GENERAL MOTORS CORP.

Disconnect the yaw rate sensor electrical connector.
Remove the two yaw rate sensor nuts (2).
Remove the yaw rate sensor (1).