Rear Toe Adjustment

WARNING: This page is about a different car, the 2007 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Suspension Adjustment Link Lock Nut & Inner Tie Rod

Courtesy of GENERAL MOTORS CORP.

Loosen the rear suspension adjustment link lock nut (1).
Rotate the inner tie rod (2) to the required toe specification setting. Refer to Wheel Alignment Specifications .

NOTE: Refer to Fastener Notice .

Tighten the rear suspension adjustment link lock nut.
Tighten: Tighten the rear suspension adjustment link lock nut to 60 N.m (44 lb ft).
Check the toe setting after tightening.
Adjust the toe setting if necessary.