Removal Procedure

CAUTION: If a window is cracked but still intact, crisscross the window with masking tape in order to reduce the risk of damage or personal injury.

IMPORTANT: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and inner trim.

Open the liftgate.
Remove the liftgate trim panel. Refer to Trim Panel Replacement - Liftgate in Body Rear End.
Remove the rear wiper motor. Refer to Wiper Motor Replacement - Rear in Wipers/Washer Systems.

Fig 1: Disconnect/Connect Rear Window Defogger Electrical Connector

Courtesy of GENERAL MOTORS CORP.

CAUTION: If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.

Cover the following parts to protect from broken glass:
1. The rear stowage compartment
2. The defroster outlets and A/C outlets
3. The seats and carpeting

Fig 2: Separating Urethane Adhesive From Window

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to GLASS AND SHEET METAL HANDLING CAUTION in Cautions and Notices.

IMPORTANT: Keep the cutting edge of the tool against the window.

Separate the urethane adhesive from the window.
- Leave a base of urethane on the pinchweld flange.
- The only suitable lubrication is clear water.
- Use J 24402-A , J 39032 or equivalent in order to remove the window. See Special Tools .

Fig 3: Identifying Liftgate Window Glass Components

Courtesy of GENERAL MOTORS CORP.

With the aid of an assistant, use the suction cups in order to lift the liftgate window (3) from the opening.