Test Description
The number below refers to the step number on the diagnostic table.
- 2: The EBCM supplies a 5-volt reference to several sensors. DTC C0870 is set if the 5-volt reference voltage is out of range.
DTC C1101
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: ABS Schematics Connector End View Reference: ABS Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 4 | Go to Diagnostic System Check - Vehicle |
| 2 | Is DTC C0870 set also? | Go to DTC C0870 | Go to Step 3 |
| 3 | Replace the electronic brake control module (EBCM). Refer to Control Module References
for replacement, setup and programming. Did you complete the replacement? |
Go to Step 4 | - |
| 4 |
|
Go to Step 1 | System OK |