Installation Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Instrument Panel Wiring Harness Connector & Antenna Cable

Courtesy of GENERAL MOTORS CORP.

Route the antenna extension cable. Secure the cable.
Connect the antenna extension cable to the radio. Install the radio. Refer to Radio Replacement .

Fig 2: Antenna Extension Cable
Courtesy of GENERAL MOTORS CORP.

IMPORTANT: The antenna cable uses a sliding snap-lock. Holding the sliding lock feature will prevent installation.
Connect the antenna extension cable from the radio to the antenna cable near the kick panel:
1. Position the antenna extension cable behind the sliding lock feature.
2. Install the antenna extension cable to the sliding lock feature.
Install the left instrument panel insulator. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages and Console.
Install the carpet.
Install the left carpet retainer. Refer to Carpet Retainer Replacement - Front (Impala) or Carpet Retainer Replacement - Front (Monte Carlo) in Interior Trim.