Front Toe Adjustment

WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Remove the small seal clamp from the inner tie rod boot.
Position the steering wheel in the straight ahead position.

Fig 1: Identifying Tie Rod & Jam Nut

Courtesy of GENERAL MOTORS CORP.

Loosen the hex nut on the tie rod (2). Turn the tie rod shaft (1) in order to obtain the proper toe angle. Refer to Wheel Alignment Specifications .
Confirm the number of threads showing on each tie rod end is nearly equal.
NOTE: Refer to Fastener Notice .
Confirm that the tie rod ends (3) are square before you tighten the lock nuts (2).
Tighten: Tighten the hex nuts at the tie rod ends to 70 N.m (52 lb ft).

IMPORTANT: Ensure the seals do not twist.
Install the seal clamps.