Rear Toe Adjustment

WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Jam Nut At Rear Wheel Spindle Rod

Courtesy of GENERAL MOTORS CORP.

Loosen the jam nuts at the rear wheel spindle rod - rear.

Fig 2: View Of Rear Toe Adjustment

Courtesy of GENERAL MOTORS CORP.

Turn the adjusting nut to change the toe angle.
Adjust the toe to the proper setting. Refer to Wheel Alignment Specifications .

Fig 3: View Of Jam Nut At Rear Wheel Spindle Rod
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .
Tighten the jam nuts on the rear wheel spindle rod - rear.
Tighten: Tighten the rear wheel spindle rod end jam nuts to 70 N.m (52 lb ft).