Repair Instructions: Flushing
WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Do not use a chemical flush.
Store used coolant in a properly labeled container. Do not pour used coolant down a drain. Ethylene glycol antifreeze is a very toxic chemical. Do not dispose of coolant into the sewer system or ground water. This is illegal and ecologically unsound.
Various methods and equipment can be used to flush the cooling system. If special equipment is used, such as a back flusher, follow the manufacturer's instruction.
When the cooling system becomes contaminated, the cooling system should be flushed thoroughly to remove the contaminants before the engine is seriously damaged.
- Drain the cooling system. Refer to Draining and Filling Cooling System (9C1, 9C3 Static Fill) or Draining and Filling Cooling System (LS4 GE 47716 Fill) or Draining and Filling Cooling System (LS4 Static Fill) or Draining and Filling Cooling System (LZE, LZ4, LZ8, 9C1, 9C3, GE47716 Fill) or Draining and Filling Cooling System (LZE, LZ4, LZ8 Static Fill) .
- Remove the coolant recovery reservoir. Refer to Coolant Recovery Reservoir Replacement (RPO LS4) or Coolant Recovery Reservoir Replacement (RPOs LZE, LZ4, LZ8) .
- Clean and flush the coolant recovery reservoir with clean, drinkable water.
- Install the coolant recovery reservoir. Refer to Coolant Recovery Reservoir Replacement (RPO LS4) or Coolant Recovery Reservoir Replacement (RPOs LZE, LZ4, LZ8) .
- Follow the drain and fill procedure using only clean, drinkable water. Refer to Draining and Filling Cooling System (9C1, 9C3 Static Fill) or Draining and Filling Cooling System (LS4 GE 47716 Fill) or Draining and Filling Cooling System (LS4 Static Fill) or Draining and Filling Cooling System (LZE, LZ4, LZ8, 9C1, 9C3, GE47716 Fill) or Draining and Filling Cooling System (LZE, LZ4, LZ8 Static Fill) .
- Run the engine for 20 minutes.
- Stop the engine.
- Drain the cooling system. Refer to Draining and Filling Cooling System (9C1, 9C3 Static Fill) or Draining and Filling Cooling System (LS4 GE 47716 Fill) or Draining and Filling Cooling System (LS4 Static Fill) or Draining and Filling Cooling System (LZE, LZ4, LZ8, 9C1, 9C3, GE47716 Fill) or Draining and Filling Cooling System (LZE, LZ4, LZ8 Static Fill) .
- Repeat the procedure if necessary, until the fluid is nearly colorless.
- Fill the cooling system. Refer to Draining and Filling Cooling System (9C1, 9C3 Static Fill) or Draining and Filling Cooling System (LS4 GE 47716 Fill) or Draining and Filling Cooling System (LS4 Static Fill) or Draining and Filling Cooling System (LZE, LZ4, LZ8, 9C1, 9C3, GE47716 Fill) or Draining and Filling Cooling System (LZE, LZ4, LZ8 Static Fill) .