LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Current Sensor Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Instrument Panel (I/P) Harness Electrical Connector
    GM1484712Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the instrument panel (I/P) harness electrical connector (1) from the battery current sensor.
  2. Remove the negative battery cable. Refer to Battery Negative Cable Replacement .
    3. Fig 2: Battery Current Sensor
    GM1475086Courtesy of GENERAL MOTORS CORP.
  3. Cut The Tie Straps And Electrical Tape Attaching The Battery Current Sensor To The Battery Cable.
  4. Squeeze the negative battery cable branches together.
    5. IMPORTANT: Note the position of the battery current sensor prior to removal.
  5. Slide the battery current sensor (1) off of the negative battery cable.
scientia non olet · About LEMON Manuals