LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Automatic Transaxle - Introduction & Repair Instructions) >> Repair Instructions >> Final Drive Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Assembling Differential Carrier
    GM214412Courtesy of GENERAL MOTORS CORP.
  1. Assemble the sun gear thrust bearing (698), the differential carrier sun gear (697), the park gear (696), the internal gear thrust bearing (695) and the sun gear shaft (689) into the differential carrier (700).
    2. Fig 2: Installing Differential Carrier
    GM214413Courtesy of GENERAL MOTORS CORP.
  2. Install the differential carrier into the case.
    3. Fig 3: Drive Axle Retainer Rings & Output Shaft
    GM214419Courtesy of GENERAL MOTORS CORP.
  3. Install the drive axle retainer rings (509) to the output shaft (510).
  4. Hold the front differential carrier in place and carefully install the output shaft to the transmission through the left wheel opening.
  5. Install the case extension housing. Refer Case Extension Housing Replacement .
  6. Install left drive axle to the transaxle. Refer to Wheel Drive Shaft Replacement in Wheel Drive Shafts.
scientia non olet · About LEMON Manuals