Manifold Pressure/Vacuum Sensor: Service and Repair

Manifold Absolute Pressure Sensor Replacement

Removal Procedure




Caution: Refer to Battery Disconnect Caution (Battery Disconnect Caution).
1. Disconnect the negative battery cable.
2. Remove the manifold absolute pressure (MAP) sensor electrical connector.
3. Disconnect the vacuum hose.
4. Remove the MAP sensor bolt.
5. Remove the MAP sensor.


Installation Procedure





Notice: Refer to Fastener Notice (Fastener Notice).

1. Install the MAP sensor with the bolt.

Tighten the MAP sensor bolt to 10 N.m (89 lb in).

2. Connect the vacuum hose.
3. Connect the MAP sensor electrical connector.
4. Connect the negative battery cable.