Vehicle Input Speed Sensor Replacement

Vehicle Input Speed Sensor Replacement

Removal Procedure





1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Disconnect the input speed sensor (1) electrical connector.
3. Remove the input speed sensor bolt.
4. Remove the input speed sensor (1) and the bracket assembly from the case.
5. Inspect the vehicle speed sensor assembly (1) for any evidence of damage.



Installation Procedure





1. Lubricate the input speed sensor seal with automatic transmission fluid.
2. Install the input speed sensor (1) and the bracket assembly.

Notice: Refer to Fastener Notice .

3. Install the bolt.

Tighten the bolt to 11 N.m (96 lb in).

4. Connect the input speed sensor electrical connector.
5. Lower the vehicle.