LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2008 >> HHR LS, Standard >> Repair and Diagnosis >> Brakes >> Anti-Lock Brake System, Traction Control System & Stability Control System >> Repair Instructions >> Brake Pressure Modulator Valve Bracket Replacement (With JL4) >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

    Fig 1: Upper BPMV Bracket Bolts
    GM1910388Courtesy of GENERAL MOTORS CORP.
  1. Install the BPMV bracket.
  2. Install the 2 upper BPMV bracket bolts (1).
    3. NOTE: Refer to Fastener Notice .
  3. Tighten the BPMV bracket bolts.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

    4. Fig 2: Brake Pressure Modulator Valve (BPMV) Bolt
    GM1910377Courtesy of GENERAL MOTORS CORP.
  4. Install the BPMV to the bracket by pressing the BPMV mounting pins into the bracket insulators until fully seated.
  5. Install the BPMV bolt (1).

    Tighten:  Tighten the bolt to 11 N.m (97 lb in).

  6. Install the brake pipes to the retainer on the wheelhouse panel.
  7. Install the cover to the ECM and the TCM.
scientia non olet · About LEMON Manuals