LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2008 >> Impala SS >> Repair and Diagnosis >> Brakes >> Anti-Lock Brake System And Traction Control System >> Diagnostic Information and Procedures >> DTC C0035-C0050 >> Circuit/System Testing
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Circuit/System Testing

IMPORTANT: It is recommend that Component Testing is performed before Circuit Testing when diagnosing wheel speed sensors.
  1. With the ignition OFF, disconnect the EBCM connector.
  2. With the ignition ON, measure for 0 volt between the sensor signal circuit terminal or the low reference circuit and ground at the EBCM connector.
    • If over 0 volt, repair short to voltage in sensor signal circuit or the low reference circuit.
  3. With the ignition OFF, measure for infinite ohms of resistance between the wheel speed sensor signal or the low reference circuit and ground at the EBCM connector.
    • If less than infinite ohms, repair short to ground in the sensor signal or the low reference circuit.
  4. Measure for 850-1350 ohms of resistance between the wheel speed sensor signal and low reference circuits at the EBCM connector.
    • If greater than 1350 ohms test for an open/high resistance in the circuit or faulty wheel speed sensor.
    • If less than 850 ohms test for a short between the circuits or faulty wheel speed sensor.
  5. If all circuits test normal replace the EBCM.
scientia non olet · About LEMON Manuals