Installation Procedure

WARNING: This page is about a different car, the 2011 Chevrolet HHR. However, it is still accessible from the selected car via links, so may be relevant.

With the aid of an assistant, install the sunroof module assembly through the liftgate opening.

Fig 1: Sunroof Module Front And Rear Drain Hoses

Courtesy of GENERAL MOTORS COMPANY

With the aid of an assistant, position the new sunroof module assembly to the studs located on the roof ring.
Install the center sunroof module to the roof. Hand tighten the nuts (2).

Fig 2: Sunroof Module Roof Nut Tightening Sequence

Courtesy of GENERAL MOTORS COMPANY

CAUTION:

Refer to Fastener Caution .

Install the remaining sunroof module (1) nuts to the module in sequence (3-8).
Tighten

Tighten all of the nuts to 10 N.m (89 lb in).

Fig 3: Sunroof Module Front And Rear Drain Hoses

Courtesy of GENERAL MOTORS COMPANY

Connect the front and rear drain hoses (1) to the drain spouts on the sunroof module.
Install the sunroof window to the new sunroof module. Refer to Sunroof Window Replacement .
Install the sunshade panel to the new sunroof module. Refer to Sunroof Sunshade Replacement .

Fig 4: View Of Sunroof Motor/Actuator Electrical Connector

Courtesy of GENERAL MOTORS COMPANY

Connect the electrical connector to the sunroof motor/actuator.
Secure the harness to the sunroof module.
Perform the initialization/teach process. Refer to Sunroof Motor/Actuator Initialization/Teach Process .
Verify the proper operation of the sunroof before securing the headliner. Refer to Headlining Trim Panel Replacement .