Door Open Switch Circuit Test -- Driver
WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the (C1 for Coupe) harness connector at the driver door lock.
- Test for less than 10 ohms of resistance between the appropriate ground circuit terminal listed below and ground.
- Base Level Sedan terminal 6
- Uplevel Sedan terminal 8
- Coupe terminal D C1
- If greater than the specified range, test the ground circuit for an open/high resistance.
- Ignition ON, verify the scan tool Driver Door Open Sw. parameter is Closed.
- If not the specified value, test the appropriate signal circuit terminal listed below for a short to ground. If the circuit tests normal, replace the BCM.
- Base Level Sedan terminal 5
- Uplevel Sedan terminal 7
- Coupe terminal C C1
- Install a 3A fused jumper wire between the appropriate signal circuit terminal listed and ground. Verify the scan tool Driver Door Open Sw. parameter is Open.
- Base Level Sedan terminal 5
- Uplevel Sedan terminal 7
- Coupe terminal C C1
- If not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the BCM.
- If all circuits test normal, test or replace the door lock.