Installation Procedure

WARNING: This page is about a different car, the 2009 Buick LaCrosse and 2009 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: RPA Receiver

Courtesy of GENERAL MOTORS CORP.

Install the RPA receiver to the rear window shelf.
Install the RPA receiver fastener.

Fig 2: Locating Rear Parking Assist (RPA) Receiver

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connector (2) to the RPA receiver.
Install the rear window shelf trim panel. Refer to REAR WINDOW SHELF TRIM PANEL REPLACEMENT .
Refer to Control Module References for programming and setup information.