LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2009 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 135 (Engine Controls And Fuel - 3.6L - Repair Instructions) >> Repair Instructions >> Accelerator Pedal Position Sensor Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

WARNING: This page is about a different car, the 2011 GMC Acadia, 2011 Chevrolet Traverse, and 2011 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of APP Sensor Bolts & Sensor
    GM1858232Courtesy of GENERAL MOTORS CORP.
  1. Install the upper bolt into the APP sensor assembly.
  2. Install the APP sensor assembly into the vehicle.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the remaining 2 lower APP sensor assembly bolts.

    Tighten 

    Tighten the bolts to 8 N.m (71 lb in).

    4. Fig 2: Identifying Accelerator Pedal Position Sensor Assembly
    GM1858231Courtesy of GENERAL MOTORS CORP.
  4. Install the I/P wiring harness electrical connector (2) to the APP sensor assembly.
  5. Install the driver knee bolster. Refer to Driver Knee Bolster Replacement (Acadia) , Driver Knee Bolster Replacement (Traverse) , Driver Knee Bolster Replacement (Enclave) .
  6. Install the left I/P insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side (Enclave) , Instrument Panel Insulator Panel Replacement - Left Side (Acadia) , Instrument Panel Insulator Panel Replacement - Left Side (Traverse) .
scientia non olet · About LEMON Manuals