Rear Toe Adjustment

WARNING: This page is about a different car, the 2010 Saturn Outlook, 2010 GMC Acadia, 2010 Chevrolet Traverse, and 2010 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Adjuster Nut

Courtesy of GENERAL MOTORS CORP.

NOTE: Make any adjustments to camber before setting toe.

NOTE: Left side toe adjustment is shown, right side toe adjustment is similar.

Loosen the adjuster nut (1).
Using a wrench to rotate the adjuster bolt (2), adjust the cam (3) to specifications.

NOTE: Ensure that the toe settings have not changed after torquing the adjuster nut to specifications. Readjust if necessary.

CAUTION: Refer to Fastener Caution .

Using a wrench to hold the adjuster bolt (2), tighten the adjuster nut (1).
Tighten: Tighten the nut to 140 N.m (103 lb ft).
Check the toe alignment and adjust if required. Refer to Rear Toe Adjustment .
Test drive the vehicle.