LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2009 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Lighting System) >> Diagnostic Information and Procedures >> DTC B2545 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2010 Saturn Outlook, 2010 GMC Acadia, 2010 Chevrolet Traverse, and 2010 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the backup lamp.
  2. Test for less than 5 Ω between the following ground circuit terminal listed below and ground:
    • RPO Z88 - terminal 1
    • RPO WDA - terminal 2
    • RPO W49/X88 - terminal B
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Connect a test lamp between the control circuit terminal listed below and the ground circuit terminal:
    • RPO Z88 - terminal 2
    • RPO WDA - terminal 1
    • RPO W49/X88 - terminal A
  4. Command the backup lamps ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.
    • If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the BCM.
    • If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.
  5. If all circuits test normal, test or replace the backup lamp.
scientia non olet · About LEMON Manuals