LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2009 >> Uplander Base, 3.9 1 >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Automatic Level Control >> Repair Instructions >> Automatic Level Control Sensor Link Ball Stud Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

  1. Remove the ELC/TRAILER fuse.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    3. Fig 1: Locating Automatic Level Control Sensor Link Ball Stud
    GM380438Courtesy of GENERAL MOTORS CORP.
    NOTE: When removing the link, do NOT bend or break the sensor arm.
  3. Remove the automatic level control sensor link from the tie rod ball stud.
  4. Remove the ball stud from the rear axle tie rod.
scientia non olet · About LEMON Manuals