Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2011 GMC Savana Special, 2011 GMC Savana Camper Special, 2011 GMC Savana, 2011 Chevrolet RV Cutaway, and 2011 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Radio Mounting Bracket & Instrument Panel Carrier Screws

Courtesy of GENERAL MOTORS CORP.

Install the radio mounting bracket. Perform the following steps:
1. Attach the HVAC harness to the radio mounting bracket with the clip.
  CAUTION: Refer to Fastener Caution .
2. Install the screws (2) in order to retain the radio mounting bracket (1) to the instrument panel carrier and tighten to 3 N.m (27 lb in).
Fig 2: Radio & Support Bracket Screws
Courtesy of GENERAL MOTORS CORP.
Connect the electrical/audio and antenna cable connectors to the radio.
Install the radio to the support bracket (1).
Align the radio locator tab into the support bracket locator hole.
Install the radio screws (2) and tighten to 2 N.m (18 lb in).
Install the instrument cluster panel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .
Calibrate the new radio assembly. Refer to Control Module References .