ECM Replacement
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 GMC Savana, 2013 GMC RV Cutaway, 2013 GMC Cutaway, 2013 Chevrolet RV Cutaway, and 2013 Chevrolet Express. However, it is still accessible from the selected car via links, so may be relevant.
If the engine control module (ECM) is replaced, the following procedures must be performed:
- Enable ECM Reprogramming-Refer to Service Programming System (SPS) .
- Perform the CKP Variation Learn-Refer to Crankshaft Position Reluctor Wheel Learn .
- Perform a Theft Deterrent Module Programming and Setup-Refer to Theft Deterrent Module Programming and Setup .
- Brake Pedal Position Sensor Learn-Refer to Brake Pedal Position Sensor Learn .
- Perform a Fuel Injector Flow Rate Programming - Refer to Fuel Injector Flow Rate Programming
- Perform a Diesel Particulate Filter (DPF) Service Regeneration Enable-Refer to Diesel Particulate Filter (DPF) Regeneration Enable .
- If over 14k GVW, program the engine serial number with the scan tool.
NOTE:
Clear any DTCs that may have set after completing the programming procedure.