Removal Procedure
Courtesy of GENERAL MOTORS COMPANY
- Remove the cover from the instrument panel (I/P) electrical center.
- Remove the RDO/CD MiniFuse® #5 from the I/P electrical center.
- Remove the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement
.
- Remove the HVAC control module. Refer to HVAC Control Module Replacement
.
- Remove the screws retaining the radio control to the I/P center support bracket.
- Begin to remove the radio control from the center support bracket enough to access the connectors at rear of the radio control.
- Disconnect the electrical/audio and coaxial cable connectors from the radio control.
- Remove the radio control.