LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2012 >> Corvette Base, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System >> Diagnostic Information and Procedures >> DTC C0710 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Verify that DTC U2100, U2142 or U2143 is not set.
  2. Verify the Yaw rate sensor and steering angle sensor mounting position is correct.
  3. Ignition OFF, disconnect the harness connector at the steering angle sensor.
  4. Test for less than 5 Ω between the ground circuit terminal 6 and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  5. Ignition ON, test for ignition voltage between the ignition voltage circuit terminal 5 and ground.
    • If not within the specified range, test the ignition voltage circuit for a short to ground or open/high resistance.
  6. Ignition OFF, disconnect the harness connector at the EBCM.
  7. Ignition ON, test for less than 1 V between the following terminal listed below and ground.
    • CAN Bus High serial data circuit terminal 37
    • CAN Bus Low serial data circuit terminal 24
    • If greater than the specified value, test the appropriate serial data circuit for a short to voltage.
  8. Ignition OFF, test for infinite resistance between the following terminal listed below and ground.
    • CAN Bus High serial data circuit terminal 37
    • CAN Bus Low serial data circuit terminal 24
    • If not the specified value, test the appropriate serial data circuit for a short to ground.
  9. Test for less than 2 Ω between the appropriate serial data circuit terminals listed below.
    • CAN Bus High serial data circuit terminal 37 at the EBCM harness connector and terminal 3 at the steering angle sensor harness connector.
    • CAN Bus Low serial data circuit terminal 24 at the EBCM harness connector and terminal 1 at the steering angle sensor harness connector.
    • If greater than the specified range, test the appropriate serial data circuit for an open/high resistance.
  10. Test for infinite resistance between the CAN Bus High serial data circuit terminal 37 and the CAN Bus Low serial data circuit terminal 24.
    • If not the specified value, repair the serial data circuits for a short together.
  11. If all circuits test normal, test or replace the steering angle sensor. If DTC resets, replace the EBCM
scientia non olet · About LEMON Manuals