LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2012 >> Orlando LTZ, Standard Trans >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System >> Repair Instructions >> Brake Pressure Modulator Valve Bracket Replacement >> Removal Procedure
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Removal Procedure

  1. Turn the ignition to the OFF position.
  2. Remove battery tray. Refer to Battery Tray Replacement (without Start/Stop System)
  3. Fig 1: Radiator Surge Tank
    GM2191081Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Do NOT disconnect engine coolant hoses.

  4. Remove the radiator surge tank clip (2).
  5. Remove the radiator surge tank (1).
  6. Position the radiator surge tank (1) aside.
  7. Fig 2: Brake Fluid Reservoir Cap And Special Tool
    GM2027346Courtesy of GENERAL MOTORS COMPANY
  8. Remove the brake fluid reservoir cap and install CH-558-10  cap (1) in order to prevent fluid loss and contamination.
  9. CAUTION:

    Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.

  10. Disconnect the electrical connector from the EBCM/EBTCM.
  11. Fig 3: BPMV Brake Lines
    GM2501292Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Cap the brake pipe fittings to prevent brake fluid loss and contamination.

  12. Remove the 6 brake pipes (1, 2) from the BPMV.
  13. Fig 4: BPMV Bracket Bolts
    GM2501297Courtesy of GENERAL MOTORS COMPANY
  14. Remove the 2 BPMV bracket bolts (2).
  15. Remove the BPMV bracket assembly (1).
  16. Fig 5: BPMV and BPMV Bracket Bolts
    GM2027916Courtesy of GENERAL MOTORS COMPANY
  17. Remove the 3 BPMV bracket bolts (4).
  18. Remove the BPMV (2).
  19. Remove the BPMV insulator (1) from the BPMV bracket (4).