Liftgate Latch Replacement

WARNING: This page is about a different car, the 2013 GMC Acadia, 2013 Chevrolet Traverse, and 2013 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Liftgate Latch

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the liftgate trim panel. Refer to Liftgate Trim Panel Replacement (Traverse) , Liftgate Trim Panel Replacement (Enclave) or Liftgate Trim Panel Replacement (Acadia) .
1	Liftgate Latch Screw (Qty: 3) CAUTION: Refer to Fastener Caution . Tighten 9 N.m (80 lb in)
2	Liftgate Latch Assembly Procedure Disconnect the electrical connector. Remove the plastic tether before installing the liftgate latch. Calibrate the liftgate. Refer to Liftgate Calibration . Adjust the liftgate if needed. Refer to Liftgate Adjustment (Acadia) , Liftgate Adjustment (Enclave) or Liftgate Adjustment (Traverse) .

Callout

Component Name

Preliminary Procedure
Remove the liftgate trim panel. Refer to Liftgate Trim Panel Replacement (Traverse) , Liftgate Trim Panel Replacement (Enclave) or Liftgate Trim Panel Replacement (Acadia) .

Liftgate Latch Screw (Qty: 3)

CAUTION:

Refer to Fastener Caution .

Tighten
9 N.m (80 lb in)

Liftgate Latch Assembly

Procedure

Disconnect the electrical connector.
Remove the plastic tether before installing the liftgate latch.
Calibrate the liftgate. Refer to Liftgate Calibration .
Adjust the liftgate if needed. Refer to Liftgate Adjustment (Acadia) , Liftgate Adjustment (Enclave) or Liftgate Adjustment (Traverse) .