Installation Procedure

WARNING: This page is about a different car, the 2013 GMC Acadia, 2013 Chevrolet Traverse, and 2013 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: BPMV Insulators

Courtesy of GENERAL MOTORS COMPANY

Install the lower BPMV bracket insulator.
Use denatured alcohol on the BPMV bracket insulator as an installation aid, if necessary.
Install the 2 upper BPMV bracket insulators.
Use denatured alcohol on the BPMV bracket insulators as an installation aid, if necessary.
Install the BPMV bracket to the BPMV.

Fig 2: BPMV Insulator Nuts And Washers

Courtesy of GENERAL MOTORS COMPANY

CAUTION:

Refer to Fastener Caution .

Install the 2 BPMV washers and nuts.
Tighten

Tighten the nuts to 8 N.m (71 lb in).

Fig 3: Front And Rear Brake Pipes

Courtesy of GENERAL MOTORS COMPANY

Install the 2 BPMV bracket nuts (2).
Tighten

Tighten the nuts to 20 N.m (15 lb ft).
Install the front and rear brake pipes (1) to the routing clip on the frame rail.
Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .