Windshield Washer Solvent Level Sensor Replacement

Preliminary Procedures

1. Remove the left front wheelhouse front liner. Refer to Front Wheelhouse Front Liner Replacement .
2. Disconnect the electrical connector from the windshield washer level sensor.
3. Place a clean suitable drain pan under the windshield washer solvent container to secure the windshield washer solvent when the level sensor and seal are removed.

Procedure

1. Using two flat-bladed tool, place the ends of the flat-blades under each side of the windshield washer solvent level sensor seal.
2. Twisting in opposite directions, pry outward, the level sensor from the washer solvent container.
3. Remove and discard the windshield washer level sensor grommet.