Circuit/System Testing
- Verify that DTC P0A3F, P0A40, P0C52, P0C53, P0C5C, P0C5D, or P1B03 are not set.
- If any of the DTCs are set, refer to DTC P0A3F, P0A40, P0C52, P0C53, P0C5C, P0C5D, or P1B03 .
- Vehicle OFF, disconnect the X175 harness connector at the transmission.
- Install the DT-44152 jumper harness to the harness side only.
- Disconnect the X1 harness connector at the T6 power inverter module.
- Test for less than 1 Ω between the terminals listed below:
- DT 44152 Terminal L and X1 terminal 1
- DT 44152 Terminal M and X1 terminal 12
- DT 44152 Terminal U and X1 terminal 2
- DT 44152 Terminal T and X1 terminal 13
- DT 44152 Terminal W and X1 terminal 3
- DT 44152 Terminal V and X1 terminal 14
- If greater that the specified range, test the signal circuit for an open/high resistance.
- If all circuits test normal, replace the drive motor generator position sensor.
NOTE:
You must perform the Component Testing before proceeding with Circuit/System Testing.