Cylinder Head Assembly

Install 10 NEW cylinder head bolts.

Tighten the bolts as shown in sequence in 5 passes, using the EN-45059 - meter:
First pass to 25 Nm (18 lb ft)
Second pass to 90 degrees
Third pass to 90 degrees
Fourth pass to 90 degrees
Final pass to 45 degrees

Refer to Cylinder Head Replacement. Service and Repair

Camshaft Bearing Cap Bolt

Install the 8 intake camshaft bearing cover bolts and tighten in a spiral from the inside to the outside to 8 Nm (71 lb in)






Install the 8 exhaust camshaft bearing cover bolts and tighten in a spiral from the inside to the outside to 8 Nm (71 lb in).


Intake Manifold Specifications

Exhaust Manifold Specifications



Camshaft Gear/Sprocket

Camshaft Position adjuster closure bolt 30Nm

Refer to Camshaft Position Actuator Adjuster Replacement. Camshaft