LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2013 >> Express 3500 V8-6.6L DSL Turbo >> Repair and Diagnosis >> Powertrain Management >> Relays and Modules - Powertrain Management >> Relays and Modules - Computers and Control Systems >> Engine Control Module >> Testing and Inspection >> Engine Control Module Programming and Setup
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Engine Control Module Programming and Setup




Engine Control Module Programming and Setup (LGH or LML)

The following service procedures require either a programming or a setup event performed for a complete repair.

ECM Replacement

If the engine control module (ECM) is replaced, the following procedures must be performed:

Note: Clear any DTCs that may have set after completing the programming procedure.

1. Enable ECM Reprogramming-Refer to Service Programming System (SPS) Service Programming System (SPS).

2. Perform the CKP Variation Learn-Refer to Crankshaft Position Reluctor Wheel Learn Testing and Inspection.

3. Perform a Theft Deterrent Module Programming and Setup-Refer to Theft Deterrent Module Programming and Setup Testing and Inspection.

4. Brake Pedal Position Sensor Learn-Refer to Brake Pedal Position Sensor Learn Programming and Relearning.

5. Perform a Fuel Injector Flow Rate Programming - Refer to Fuel Injector Flow Rate Programming Fuel Injector Flow Rate Programming

6. Perform a Diesel Particulate Filter (DPF) Service Regeneration Enable-Refer to Diesel Particulate Filter (DPF) Regeneration Enable Diesel Particulate Filter (DPF) Regeneration Enable.

ECM Reprogramming

Note: Clear any DTCs that may have set after completing the programming procedure.

Enable ECM Reprogramming-Refer to Service Programming System (SPS) Service Programming System (SPS).

scientia non olet · About LEMON Manuals