LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2013 >> Impala LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 366 (Anti-Lock Brake System And Traction Control System) >> Diagnostic Information and Procedures >> DTC C0186 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2008 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. If DTC C0252 is set, diagnose that DTC first.
  2. Ignition OFF, disconnect the yaw and lateral accelerometer sensor connector.
  3. Ignition OFF, test for less than 1 ohm of resistance between the ground circuit terminal and ground.
    • If greater than 1 ohm, test the ground circuit terminal and the EBCM ground circuit terminal for a short to voltage or an open/high resistance. If the circuits test normal, replace the EBCM.
  4. Test the lateral accelerometer signal circuit terminal, the 5 volt reference circuit terminal, and the ground circuit terminal for an open/high resistance or a short to voltage or ground.
    • If all circuits test normal, replace the yaw and lateral accelerometer sensor, and clear the yaw rate sensor offset value in the EBCM.
    • If the DTC sets again after replacing the yaw and lateral acceleration sensor, replace the EBCM.
scientia non olet · About LEMON Manuals