LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2013 >> Silverado 1500 XFE >> Repair and Diagnosis >> Body & Frame >> Windows >> Fixed And MOVEABLE Window System >> Repair Instructions >> Windshield Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Install a stationary window into the opening. Refer to Adhesive Installation of Stationary Windows (Windshield) , Adhesive Installation of Stationary Windows (Rear Window) .
    2. Fig 1: View Of Reveal Molding
    GM1743197Courtesy of GENERAL MOTORS COMPANY
  2. Install the window side reveal moldings to the vehicle.
    3. Fig 2: Removing/Installing Screws From Window Side Reveal Moldings
    GM1743200Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  3. Install the screws to the left and the right sides of the window side reveal moldings.

    Tighten 

    Tighten the screws to 2 N.m (18 lb in).

    4. Fig 3: View Of Front Door Sealing Weatherstrips & Side Reveal Molding Screws
    GM1743196Courtesy of GENERAL MOTORS COMPANY
  4. Install the front door sealing weatherstrips (1) to the retainer (2).
  5. Install the cowl air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
  6. Install the window wiper arms. Refer to Windshield Wiper Arm Replacement .
  7. Install the antenna mast, if equipped. Refer to Radio Antenna Replacement .
  8. Install the outside moisture sensor lens. Refer to Windshield Outside Moisture Sensor Lens Replacement .
  9. Install the inside rearview mirror. Refer to Inside Rearview Mirror Replacement .
  10. Close the hood.
  11. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
scientia non olet · About LEMON Manuals