Installation Procedure
- If reusing the spark plugs, Refer to Spark Plug Inspection .
- If using NEW spark plugs do not attempt to check gap or damage can occur, plugs come pre gapped.
- Hand start the spark plugs.
- Tighten the spark plugs. Tighten the NEW engine spark plug to 20 N.m (15 lb ft) and the engine spark plug on subsequent installations to 15 N.m (11 lb ft).
- Install the spark plug wires. Refer to Spark Plug Wire Replacement .
- Install the intake manifold cover. Refer to Intake Manifold Cover Replacement (Right Side)Intake Manifold Cover Replacement (Left Side) .
NOTE:
If the old spark plugs are being reused, ensure they are installed in the corresponding cylinders.
CAUTION:
Refer to Component Fastener Tightening Caution .