Installation Procedure
- Install the radio mounting bracket. Perform the following steps:
- Attach the HVAC harness to the radio mounting bracket with the clip.
- Install the screws (2) in order to retain the radio mounting bracket (1) to the instrument panel carrier and tighten to 3 N.m (27 lb in).
CAUTION:Refer to Fastener Caution .
- Connect the electrical/audio and antenna cable connectors to the radio.
- Install the radio to the support bracket (1).
- Align the radio locator tab into the support bracket locator hole.
- Install the radio screws (2) and tighten to 2 N.m (18 lb in).
- Install the instrument cluster panel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .
- Calibrate the new radio assembly. Refer to Control Module References .