LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2014 >> Express 1500 LS, RWD >> Repair and Diagnosis >> Body & Frame >> Windows >> Fixed And MOVEABLE Window System >> Repair Instructions >> Windshield Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

    NOTE:

    Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.

  1. Remove the windshield wiper arms. Refer to Windshield Wiper Arm Replacement .
  2. Open the hood.
  3. Remove the air inlet grille. Refer to Air Inlet Grille Panel Replacement .
  4. Remove the windshield frame filler panel. Refer to Upper Front Fender Filler Panel Replacement .
  5. Remove the inside rearview mirror. Refer to Inside Rearview Mirror Replacement .
    6. WARNING:

    Refer to Defroster Outlet Warning .

  6. Cover to protect the following parts from broken glass:
    • The upper dash pad
    • The defroster outlets and A/C outlets
    • The seats
    • The carpeting
  7. Remove the defroster vent grille. Refer to Instrument Panel Upper Trim Pad Replacement .
  8. Remove the windshield upper garnish moldings. Refer to Upper Pillar Garnish Molding Replacement .
    9. Fig 1: Using Utility Knife To Remove Reveal Molding
    GM379905Courtesy of GENERAL MOTORS COMPANY
    WARNING:

    Refer to Glass and Sheet Metal Handling Warning .

  9. Using a sharp utility knife, carefully cut the edge of the lace (1) in order to expose the urethane adhesive bead.
  10. Apply a double layer of masking tape to the edge of the roof panel and A-pillars.
    11. Fig 2: Identifying Lower Windshield Supports
    GM326804Courtesy of GENERAL MOTORS COMPANY
  11. Remove the lower windshield supports (1) from the plenum panel, if equipped.
    12. Fig 3: Separating Urethane Adhesive From Window
    GM71179Courtesy of GENERAL MOTORS COMPANY
  12. Keep the cutting edge of the tool against the window. This will allow the urethane adhesive to be separated from the window.
    • Leave a base of urethane on the pinchweld flange.
    • The only suitable lubrication is clear water.
    • Use J 24402-A  glass sealant remover (cold knife), J 39032  stationary glass removal tool or equivalent in order to remove the window.
    13. Fig 4: Separating Bottom Of Window
    GM379883Courtesy of GENERAL MOTORS COMPANY
  13. Remove the bottom of the window from the urethane adhesive using a long utility knife or similar tool. Keep the cutting edge of the utility knife against the glass. Do this from inside the vehicle.
    14. Fig 5: Identifying Assistant And Windshield
    GM441419Courtesy of GENERAL MOTORS COMPANY
  14. Remove the windshield (1) from the vehicle with the aid of an assistant (2).
scientia non olet · About LEMON Manuals