LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2014 >> Traverse LS, 4D Utility >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Antilock Brake System) >> Repair Instructions >> Rear Wheel Speed Sensor Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

WARNING: This page is about a different car, the 2015 GMC Acadia, 2015 Chevrolet Traverse, and 2015 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Wheel Speed Sensor Bolt
    GM1861969Courtesy of GENERAL MOTORS COMPANY
  1. Install the wheel speed sensor to the wheel knuckle.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the wheel speed sensor bolt.

    Tighten 

    Tighten the bolt to 9 N.m (80 lb in).

    3. Fig 2: View Of Wheel Speed Sensor Wire Harness Routing Clip
    GM1861966Courtesy of GENERAL MOTORS COMPANY
  3. Install the wheel speed sensor wire harness routing clips to the upper suspension link.
    4. Fig 3: Identifying Wheel Speed Sensor Electrical Connector
    GM1861964Courtesy of GENERAL MOTORS COMPANY
  4. Install the wheel speed sensor wire harness routing clips (3) to the upper suspension link.
  5. Install the wheel speed sensor wire harness grommet (2) to the lower control arm bracket.
  6. Connect the wheel speed sensor electrical connector (1).
  7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  8. Perform the Diagnostic System Check - Vehicle .
scientia non olet · About LEMON Manuals