LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2015 >> Impala Limited LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Front Suspension System) >> Specifications >> Fastener Specifications
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Fastener Specifications

WARNING: This page is about a different car, the 2015 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
Application Specification
Metric English
Front Lower Control Arm Front Bolt (Requires a NEW bolt.) 
  • First Pass:
 100 N.m 74 lb ft
  • Final Pass:
 90-105 degrees
Front Lower Control Arm Rear Bolt (Requires a NEW bolt.) 
  • First Pass:
 100 N.m 74 lb ft
  • Final Pass:
 75-90 degrees
Front Stabilizer Shaft Insulator Clamp Bolt (Requires a NEW bolt.) 
  • First Pass:
 22 N.m 16 lb ft
  • Final Pass:
 30-45 degrees
Front Stabilizer Shaft Link Nut 65 N.m 48 lb ft
Front Suspension Strut Mount Nut 55 N.m 41 lb ft
Front Suspension Strut Nut 70 N.m 52 lb ft
Front Wheel Bearing and Hub Assembly Bolt
  • First Pass:
 100 N.m 74 lb ft
  • Final Pass:
 60-75 degrees
Steering Knuckle Nut (at Front Lower Control Arm) (Requires a NEW bolt.) 
  • First Pass:
 50 N.m 37 lb ft
  • Second Pass:
 Loosen 120 degrees
  • Third Pass:
 50 N.m 37 lb ft
  • Final Pass:
 30-45 degrees
Steering Knuckle Nut (at Steering Knuckle) (Requires a NEW bolt.) 
  • First Pass:
 85 N.m 63 lb ft
  • Final Pass:
 60-75 degrees
scientia non olet · About LEMON Manuals